GPIO

Generic GPIO module for transparently handling physical pins and pins controlled by port expanders.

The module can be used without configuration like this:

import gpio


gpio.mode(D10, OUTPUT)  # Set mode for D10
gpio.mode(D11, OUTPUT)  # Set mode for D11
gpio.high(D10)          # Set D10 high
gpio.low(D11)           # Set D11 low

More advanced configurations allow the use of port expanders:

import gpio
from semtech.sx1503 import sx1503    # a port expander driver for sx1503

# initialize port expander driver
pdriver = sx1503.SX1503(I2C0)        # sx1503 is connected on I2C0

pinmap = {                           # now add pins definition for the expander
    100: 7,                          # pin "100" maps to pin 7 on sx1503
    101: 14,                         # pin "101" maps to pin 14 on sx1503
    102: 15                          # pin "102" maps to pin 15 on sx1503
}

gpio.add_expander(1,pdriver,pinmap)  # add expander to gpio module
                                     # with id = 1, using pdriver
                                     # and mapping the pins in pinmap

# from here on, every library using gpio can access the port expander
# without knowing about its existence! Like this:

mypin1 = D10
mypin2 = 100

gpio.mode(mypin1,OUTPUT)             # configure D10 as output
gpio.mode(mypin2,OUTPUT)             # configure pin "100" as output on sx1503

gpio.high(mypin1)                    # set pin D10 to high
gpio.low(mypin2)                     # set pin "100" to low

high(pin)

Set the value of pin to HIGH. If the module is configured with one or more port expanders, the value of pin is set by calling into the port expander driver.

low(pin)

Set the value of pin to LOW. If the module is configured with one or more port expanders, the value of pin is set by calling into the port expander driver.

set(pin, value)

Set the value of pin to value. If the module is configured with one or more port expanders, the value of pin is set by calling into the port expander driver.

get(pin)

Return the value of pin. If the module is configured with one or more port expanders, the value of pin is returned by calling into the port expander driver.

mode(pin, pinmode)

Set the mode of pin to pinmode. If the module is configured with one or more port expanders, the mode of pin is set by calling into the port expander driver. For available modes please check here.

add_expander(id, pdriver, pinmap)

Add pdriver and pinmap as expander id to the list of available expanders. pdriver must be a port expander driver, pinmap must be a dictionary mapping pin names to the port expander internal representation.