RedBear Nano 2

The RedBear Nano 2 is a microcontroller board based on the Nordic NRF52832 Cortex-M4F MCU.

It is a tiny board based on the MB-N2 module by RedBear with an U.FL connector for externak NFC antenna.

RedBear Nano 2
RedBear DAP Link board

Pin Mapping

RedBear Nano 2

Flash Layout

The internal flash of the NRF52832 is organized as a single bank of 512Kb, with pages of 4Kb each. The flash begins at address 0x00000.

Board Summary

  • Microcontroller: NRF52832
  • Operating Voltage: 3.3V
  • Digital I/O Pins (DIO): 12
  • Analog Input Pins (ADC): 6
  • Analog Outputs Pins (DAC): 0
  • UARTs: 1
  • SPIs: 1
  • I2Cs: 1
  • Flash Memory: 512 Kb
  • SRAM: 64 Kb
  • Clock Speed: 64 MHz
  • Size (LxW mm): 18.0 x 21.0


The RedBear Nano 2 can be powered via the USB connector of the companion DAP Link adapter or with an external power supply.

Connect, Virtualize and Program

The RedBear Nano 2 can be programmed through the companion DAP Link adapter that exposes three USB interfaces:

  • A serial port over USB
  • A mass storage device for drag-n-drop programming flash memory
  • A DAP compliant debug channel

DAP Link should be supported natively by all platforms. Once connected to a USB port, the RedBear Nano 2 + DAP Link board is recognized by Zerynth Studio. The board can be virtualized by clicking the related Studio button without requiring any other user intervention.

Follow these steps to uplink a Zerynth script on a virtualized RedBear Nano 2:

  • Select the Nano 2 on the Device Management Toolbar;
  • Register the device by clicking the “Z” button from the Zerynth Studio;
  • Create a Virtual Machine for the device by clicking the “Z” button for the second time;
  • Virtualize the device by clicking the “Z” button for the third time.

After virtualization, the device is ready to be programmed and the Zerynth scripts uploaded. Just Select the virtualized device from the “Device Management Toolbar” and click the dedicated “upload” button of Zerynth Studio and reset the device by pressing the Reset on-board button when asked.


To exploit the BLE chip functionalities of the Nano 2, the lib.nordic.nrf52_ble library must be installed and imported on the Zerynth script. Moreover, in the creation phase, a VM with BLE support must be selected.